Cross Section Point Properties
Edit the Points on a cross section
This is the point in the job which is used to store the CS values
Enter the point offset from the longsection point. When you change this value the point will be moved in Easting/Northing along the cross section to the required offset.
Enter the natural surface height value. This is the same as the point Z(Height) value.
This is the design surface height (RL). This cannot be edited, it will be computed when the cross section design is computed using the templates.
This is the design boxing level height. This cannot be edited, it will be computed when the cross section design is computed using the templates.
This is the point code.
Press this button to move to the previous point on the cross section
Press this button to move to the next point on the cross section
General information and Frequently Asked Question.