Cross Section Template Properties
Edit Cross Section Templates
Change the template name. Be careful, the program will not automatically update any Cross sections
using this template to the new name.
Enter a text description for the template. This is not used by the program. it is for your reference.
Cut Batter %
Define the cut batter to be used when the edge of the template is in cut (underground).
This is the slope of the line as a percentage (height over width).
Fill Batter %
Define the fill batter to be used when the edge of the template is in fill (above ground).
This is the slope of the line as a percentage (height over width). Usually a Negtive value.
There are two types of templates, ‘File’ templates are read/written to the templates file
(if specified). ‘Job’ templates will be saved in the actual job. You can change a template
from ‘File’ to ‘job’ in the template properties.
General information and Frequently Asked Question.