Insert Road Point
Inserts a new chainage point into the longsection.
Note that this will also insert a new point into the job, and will insert that point into
the corresponding String for this longsection.
The Easting and Northing values for the new point will be interpolated using the horizontal
geometry of the string.
This is the point number which will be created and inserted into the longsection and the string.
Enter the chainage of the point on the longsection
Enter the start chainage of the longsection to be created.
Enter an Intersection Point Level (or Design level) if required at this point
Start VC Length
This is the length of the vertical curve which ends at this point. This should only be entered if an IP Level is defined.
End VC Length
This is the length of the vertical curve which starts at this point. This should only be entered if an IP Level is defined.
The name of the template to be used to perform the cross section design on the left for this point.
The name of the template to be used to perform the cross section design on the right for this point.
The cross section template design offset from the centre.
Enter an optional text description of this point.
General information and Frequently Asked Question.