Contents   Index  

Add Node Point

This option will convert a Line point to a Node Point.

It is useful where there are number of new parcels on an old boundary and it is difficult to get the line points to stay on the boundary. If it is likely that the old boundary may not be a straight line, then it is could be appropriate to convert one or more of the line points to be node points.

Select the line point with the mouse and the Plan, Lot, Line and line point number will be displayed in the dialogue box. The plan and line will also be highlighted.

If the change is accepted, the selected line will be made into two lines each with the bearing of the old line. If the bearing of the line was a “true Mid Bearing”, then equivalent true mid bearings will be given to each segment.

The sum of the two segments will equal the original line length.