Add Line Point

The ‘Add Line Point’ option allows the addition of a line point which may have been missed during the joining process.

Start Line
Use the mouse to select the start of the line, click the point.
Or, click on the line to select the start/end pts in one go.
Or, if there aremultiple lines on top of one another, right click on the line and select your line.

End Line
Use the mouse to select the end of the line, click the point.

Line Point
Then, use the mouse to select the corner to be linked to the line.

Offset
This is the offset of the point from the line.

Accept
The point can either be accepted, or another point tried, or the point can be rejected by exiting the dialogue box.



Move Pt Onto Line
Press to move the point onto the line and the offset will be reduced to 0.0
This is only enabled/allowed after you create the line point.